| HyOx Part Name |
Possible Substitute Part |
| Heavy Duty HyOx Generation Container Module |
1 each: 4" Diameter Electrical Conduit or PVC Pipe X 6" long |
| Integrated Gas Molecule/Electronics Distribution Cap |
2 each: 4" Electrical Conduit or PVC Pipe Caps |
| Heat proof / water proof sealant |
1 tube: Teflon or PVC or Pipe Cement (teflon is the best) |
| Snap-In Electrodes |
2 each: 3/8" X 6" Nickel Steel Stove Bolts (regular steel or galvanized will corrode) |
| Clamp-on Insulated Alternator Connector |
1/2: Jumper Cable or 1 heavy duty Electrical Test Clip (Red Connector) |
| Clamp-on Insulated Ground Connector |
1/2: Jumper Cable or 1 heavy duty Electrical Test Clip (#000000 Connector) |
| Slip-in/Clamp-on Molecule Feed Hose |
1 each: 3 feet of rubber/vinyl or hydraulic hose |
| Clip-on Throttle/Intake Hose Clip |
1 each: 3-4" piece of Steel Wire |
| Module Retainer Strap |
1 each: 6-12" Rubber Bungee Cord or Steel Wire |
| Easy Fill Funnel |
1 each: Plastic or Metal Funnel |
| Electrolyte Ingredients |
1 bottle: Hydrogen Peroxide, 1 box: Baking Soda |
| Gas Mileage Savings Calculator |
Click Here |
Assembly / Install Instructions
Prepare one end of the Container Module and first cap with Teflon or PVC sealant
Seal the first cap (water tight) onto the prepared end of the Container Module (this will be the bottom)
Secure the Container module to the inside the engine compartment (fender wall) with cord or steel wire
In the second Cap, Drill two 3/8" holes for the Electrodes
In the second Cap, Drill one 1/4" hole for the Feed Hose
Insert the 2 Electrodes in the 3/8" cap holes and secure in place with sealant (make air tight)
Slip the Feed Hose into the 1/4" cap hole and secure in place with sealant (make air tight)
Put about 1/8 cup of Hydrogen Peroxide and/or 1 teaspoon baking soda into the Container Module
Fill the Container Module about 1/2 to 3/4 full with plain tap water or seawater
Snap the second Cap with hose and electrodes onto the (top) of the Container Module
Clip or attach the feed hose into the air intake (anywhere above the throttle butterfly)
Attach the #000000 Cable between 1 Electrode and any bare metal (grounded) body or engine part
Attach the Red Cable between the other electrode and the Alternator Positive Connector
Start the Engine - the unit will begin producing Hydrogen and Oxygen and feeding it to the engine
The Engine Control Unit (ECU) in your vehicle should automatically adjust idle, fuel mixture etc.
OPTIONAL: If you want fusion energy, try using Palladium electrodes and seawater (WOW).